UP SWITCH INSPECTION [SJ6A-EL]
2016 – MX-5 – Transmission/Transaxle
UP SWITCH INSPECTION [SJ6A-EL]
Continuity Inspection
NOTE:
-
The up position switch is built into the selector lever component.
1. Disconnect the negative battery cable. (See NEGATIVE BATTERY CABLE DISCONNECTION/CONNECTION.)
2. Remove the following parts:
a. Selector lever knob (See AUTOMATIC TRANSMISSION SHIFT MECHANISM REMOVAL/INSTALLATION.)
b. Shift panel component (See SHIFT PANEL REMOVAL/INSTALLATION.)
3. Disconnect the selector lever component connector.
4. Verify that the continuity between selector lever component terminals C and H.
-
If not as verified, replace the selector lever component. (See AUTOMATIC TRANSMISSION SHIFT MECHANISM REMOVAL/INSTALLATION.)
Up switch specification
|
Test condition |
Continuity |
|
Selector lever is in the M position (+) side position. |
Continuity |
|
Selector lever is not in the M position (+) side position. |
No continuity |